To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others. To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several to HP support community You can refer this HP document for more assistance:- Click here ![]() If the error message persists, repeat the steps to reseat the printhead up to three times. Received message on HP Officejet Pro 8610 e-All-in-One Printer that 'The printhead appears tp be missing, not detected, or incorrectly installed.' Followed instructions to remove and reinstall printhead but problem persists. Sometimes error messages persist after inserting the printhead. Reconnect the power cord to the rear of the printer, and then check the control panel for the error message. Lift the carriage latch, slightly lift the printhead, lower the printhead back into the carriage, wiggle the printhead left and right, and then lower the carriage latch to lock the printhead into place. You must disconnect the power cord before reaching inside the printer. Unplug the power cord from the rear of the printer. Wait until the carriage stops moving before you continue. Open the door to access to the ink cartridges.
0 Comments
Leave a Reply. |